HI All, I am currently developing a product that will use both the MCP CAN chips and also the TLC5940 LED Driver chip, Both items run off Serial, and so i have to move the LED drive to Bit Banging mode, ( not a problem in itself ) but i also need to move the Blanking function pin of the TLC5940 fr…

TLC5940 Changine to Bit Banging and Move Blank Pin????

Rich_P November 22, 2012, 9:34pm 11

I'm sorry but I'm not quite knowledgeable enough on this to understand how to make the changes,
Are you willing to give me step by step instructions?

Many thanks

Rich

Topic		Replies	Views
Running 2 serial devices from an Arduino? CAN chip and TLC5940 Networking, Protocols, and Devices	19	5253	May 6, 2021
Arduino Ethernet Board + TLC5940NT LED Driver Feasibility Project Guidance	1	539	May 5, 2021
Is there a way to change the pins used in the tlc5940 library? LEDs and Multiplexing	3	825	May 6, 2021
Leonardo+TLC5940+Ethernet Shield Project Guidance	13	3057	May 5, 2021
TLC connection Programming Questions	11	2435	May 5, 2021