Hello! i'm trying to read gps(global sat et-332) tx output using arduino mega 2560 i've connected gps tx to arduino rx1 gps configured to work in nmea mode, if i connect it to pc - i get perfect nmea output but when i when i run this code on arduino void setup() { // initialize both serial po…

problems reading gps output

Using Arduino Networking, Protocols, and Devices

system July 15, 2012, 7:53pm 8

Hmm- I can't get the sheet to open from USGlobalsat. But the board I have from them runs at 4800 baud, default- might be worth a quick try just to see...

Topic		Replies	Views
Problem reading serial data Networking, Protocols, and Devices	12	2947	May 6, 2021
Reading GPS (NMEA) data to serial monitor Networking, Protocols, and Devices	8	8571	May 6, 2021
NMEA serial write problem Programming Questions	5	1486	May 5, 2021
arduino GPS problem. Programming Questions	4	1174	May 5, 2021
Global top PA6H small gps module Networking, Protocols, and Devices	10	3881	May 6, 2021

problems reading gps output

Related Topics