Hi All,
I am having a problem with my Arduino Pro Mini clone (Atmega328) Duemilanove
When uploading a sketch I receive either the error 0x82 or 0x83 on Linux (the LED's start flashing when trying to upload).
When uploading through Windows I get a 0x02 error (LED's also flash normally)
The main LED is lit and there is one blinking LED - about every 2 seconds, which according to what I read is that the bootloader is working.
There is nothing connected to the board, just the FTDI cable which provides 6.4V to the board (max12).
I tried the reset button trick and without
I changed the Baud rate from various 9600 to 115200
I run on Linux (FC16) with a serial-USB cable, but also tried on native Windows7 and WinXP through virualization.
I used avrdude directly I tried several commands like
/usr/bin/avrdude -C/etc/avrdude/avrdude.conf -v -v -v -v -patmega328p -cstk500v1 -P/dev/ttyUSB1 -b57600 -D -Uflash:w:/tmp/build8973257987213556989.tmp/BareMinimum.cpp.hex:i
changing the baud values here and also replacing -cstk500v1 with -carduino
I believed I have tried every possible configuration and all ended up with these error(s)....
Although if I change the speed to higher values i get the error 0xf0 or 0xff back.
Anybody ever encountered anything like this? do I need to get an AVR programmer?
Thanks in advance
Oscar