MarkT:
I could, but I'm sure you can do that too[ you will need to identify a good component supplier though - I'd suggest Farnell or associates, but it varies by territory ]
What do you mean by "farnell or associates" ?
BTW,I made the schematic using circuit lab,here it is https://www.circuitlab.com/circuit/dx43y5/arduino-theremin/,values in the schematic are not so correct(ignore them).
Correct me if I am wrong somewhere about the required components:
- 2x Resistors ,each of 100k ohm
- Capacitor C1 of value 150p of type NP0
- Capacitor C3 and C4 of value 10p
- Capacitor C2 of value 100n
- Inductor L1 of value 10uH
- IC1 {unknown mystery}
What IC is to be used,I still do not get it,the values are correct? and the schematic I made is also right?
The antenna made of wire is to be connected from "ANT" to "F _OUT" nodes?
The Male header pins are to be connected to +5V,2 ground connectors,and Vin
What is to be connected to Vin,the F Out or what?