Go Down

Topic: Error while uploading code into ESP8266 using an Arduino Uno (Read 60 times) previous topic - next topic

lonewulfe

I tried flashing code into an ESP8266 module which was hooked up with an Arduino using Arduino IDE but it showed this error

error: failed reading byte
warning: espcomm_send_command: cant receive slip payload data
error: failed reading byte
warning: espcomm_send_command: cant receive slip payload data
error: failed reading byte
warning: espcomm_send_command: cant receive slip payload data
error: failed reading byte
warning: espcomm_send_command: cant receive slip payload data
error: failed reading byte
warning: espcomm_send_command: cant receive slip payload data
error: failed reading byte
warning: espcomm_send_command: cant receive slip payload data
warning: espcomm_sync failed
error: espcomm_open failed
error: espcomm_upload_mem failed

Any ideas on how to fix this?

Ezequiel1506

I had some problems with this module.
First I built a board like this:


Then, in my arduino, I putted Reset pin to GND.
And I uploaded mi program. Is important that PROG  button must be pressed until your program be upload.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy