hi-
thanks for replying! =)
Can you explain what it is you are doing different?
I have little experience with electronics/hardware.. but 'to me'.. I dont see any change?
I see that you have connected all the GND traces.. 'before'... terminating on the GND rail?
Is that the only difference?
and can you explain how this changes things?
I have GND on the outside rails of the breadboard..
this GND rail is from my vReg GND output..
I have all GND traces terminating on the GND rail around my breadboard.. isnt this the same thing?
according to pin-out.. the 'center pin; is the wiper.. so I believe that to be correct
ok I just tried to connect all GNDs in-line before terinating to the GND rail.. still 'no change'.
I can hear a HUM like the speaker has power.. and if I adjust the pot.. the 'hum' (static..not sure how to explain it) goes up or down a bit.. but no audio is playing...
I plug in the RadioShack crap pre-amp speaker..and it 'works'.. (although the sound is KAKA) LOL
Not sure what Im doing wrong?
I'l try the 1 & 8 pins..
what cap should I use? 10uF? 22uF?
Thanks