hi i been searching hi and low and would like some advice on how to burn the Duemelinove w/328 bootloader to a breadboard setup using the USB2SERIAL Light adaptor
please if some one can help or point me to the correct link for a tutorial
thanks
hi i been searching hi and low and would like some advice on how to burn the Duemelinove w/328 bootloader to a breadboard setup using the USB2SERIAL Light adaptor
please if some one can help or point me to the correct link for a tutorial
thanks
a link to the part? Ya Thimk?
its an officail Arduino product so i assumed it would be known
Sorry
here is link
silverfox0786:
its an officail Arduino product so i assumed it would be knownSorry
here is link
That will not be enough to program a target chip via ISP. You need to use an arduino board running the arduinoISP sketch or one of several ISP hardware programmer modules that the arduino IDE can support.
Your device is just a USB TTL serial converter module.
Lefty
that clears up a bit of confusion then
i assumed it was possible as it had a ISCP pinout header on it
i guess thats used to program the adaptor itself
thanks for clesaring that up for me
can someone recomend a cheap enough ISCP programmer in UK
thanks
You're off by a letter HobbyKing is located in HK, Farnell is in UK 8)
CrossRoads:
You're off by a letter HobbyKing is located in HK, Farnell is in UK 8)
But they ship worldwide.
cheers guys
such a great community
glad i decided to get into Arduino as well as Raspberry Pi