Go Down

Topic: How To Controlling Linak actuators with arduino (Read 213 times) previous topic - next topic

d_rhoades

Aug 13, 2017, 02:53 pm Last Edit: Aug 13, 2017, 02:59 pm by d_rhoades
Hello. I recently obtained a hospital bed that a friend was throwing away. It has 2 small and 2 large Linak actuators. They each have 6 wires that run to the control box (Black, Red, Orange, Yellow, Green, and Brown). I haven't found any doc or datasheet on Linak wire color codes. And it didn't come with the plug-in controller or power supply. The sticker on the actuators says that they are 24VDC, 2 are 5A and 2 are 4.4A. I can't open any of them up without breaking the plastic housing. Is there a standard for linear actuator color codes?Any info I can get on how to control these actuators with arduino would be greatly appreciated. Thanks.

Go Up