UART Camera Module RS232 connect to arduino

Using Arduino Storage
1

i have some prbleme wiht this cam(UART Camera Module RS232 ) when i connected it to arduino ,am using the adafruit library and code

my question is :why i need need to remove MAX3232 chip from this camera only after the receipt of Arduino UNO board.?

and there's any solution other removing this chip
please loock this site after reply :
http://iteyes.blog.sohu.com/rss

thanks

2

????????????,?????RS232???,?????MAX3232??????,????Arduino UNO????.

The MAX3232 takes 0-5V signal and outputs +- 13.2V. You can only use 0-5V signal on Arduino so remove the chip.

The second picture is pretty clear:

http://iteyes.blog.sohu.com/258657374.html

There is an empty foot print for a chip and two jumper wires were soldered on. If you don't order RS232 version by mistake you don't need this step.

Do you have this exact camera?

You need to know this too:

????????TTL???3.3V?,????5V?Arduino????,????????10K??????????,??????????.

3

thanks you for your help :slight_smile:
yes i have the same camera ,,i will try to do the same things in the link that you sent to me
and if i have an other problem i will ask you again :slight_smile:

4

I have a few water-proof version of this camera. If you use hardware serial, it's working fine. If you use software serial, too many frames are garbled (10%).