Hi All, Can anyone shine some light on this, I have an UNO Clone 328 chip with a bootloader installed, also installed is a 'blinky' sketch, working as expected (the chip was programmed in an UNO board). The problem is if I try to reprogram the chip using a known working FTDI cable (5V version). Al…

Programming an UNO clone using a FTDI cable

Docedison January 14, 2013, 1:02am 9

The Label is wrong on the power jumper.. It sez Default 3V3 and is shown 'jumpered' to 5 V.

Bob

Topic		Replies	Views
Programming the Arduino Mini IDE 1.x	4	1160	May 5, 2021
Optiboot with FTDI Problems.. Microcontrollers	38	14300	May 6, 2021
Using an FTDI cable Project Guidance	4	1692	May 5, 2021
[solved] Trouble programming pro mini 328 5v via FTDI IDE 1.x	2	973	May 5, 2021
Programming Mini using Uno IDE 1.x	6	11911	May 5, 2021