Go Down

Topic: IR Sensor and Remote (Read 116 times) previous topic - next topic

chap6595

I am working with some student at school, trying to get an IR Receiver to turn a motor. I am having an issue with the remote, giving different reading every time. I want the IR Receiver to detect a signal and then turn a SERVO 90 degrees.


Here are the Codes i received pressing the same button on a AC Remote.

C1A6613E
C509B7F9
B258ECED
5D0F829A
4C73FC95
F2318C8B
5A535141
541D7E9
5A172971
FB91650C
9D549C3A
233AC560
D277E549
5C0C6A0
30F23B53
388B8B37
7C4FDAF9
7BA53359
975CC33B
9D5243DE



Here is the basic code:

/*
 * IRremote: IRrecvDemo - demonstrates receiving IR codes with IRrecv
 * An IR detector/demodulator must be connected to the input RECV_PIN.
 * Version 0.1 July, 2009
 * Copyright 2009 Ken Shirriff
 * http://arcfn.com
 */

#include <IRremote.h>

int RECV_PIN = 2;

IRrecv irrecv(RECV_PIN);

decode_results results;

void setup()
{
  Serial.begin(9600);
  irrecv.enableIRIn(); // Start the receiver
}

void loop() {
  if (irrecv.decode(&results)) {
    Serial.println(results.value, HEX);
    irrecv.resume(); // Receive the next value
  }
  delay(10);
}



Any ideas on the issue with the code?

What code would I have to put in for the servo to turn 90 degrees?????

Thanks


Riva

Quote
Here are the Codes i received pressing the same button on a AC Remote.
If your using a Air Conditioning remote then some of them send IR packets that are to big for the default IR detector and/or they don't use standard IR protocols so you need to capture & send raw codes.
Don't PM me for help as I will ignore it.

Go Up