Hi all, I need a little help. I have written a simple little sketch involving 3 LED's and A Push Button. It works fine on the Bread Board hooked up to the Arduino UNO. But when I put the code on a atTiny85 it wont run. I know I am programming the chip right. I have tested it with the Blink sketch…

Help with shrinking program on to Tiny85

strykeroz January 2, 2013, 4:22am 4

Sorry that was a typo. You are correct.

Topic		Replies	Views
Going from Uno to ATTINY85 for controlling LEDs Microcontrollers	2	766	May 6, 2021
ATTINY85 LED strip + push button Microcontrollers	3	1763	May 6, 2021
Arduino attiny85 led IR remote Microcontrollers	3	1428	May 6, 2021
can't figure out Interrupt for Tiny Programming Questions	9	3371	May 5, 2021
Problem programming an Attiny85 Programming Questions	6	1684	May 5, 2021