When you have a moment, please remember set the github repository to public, and update the "source code to the Arduino software is hosted by GitHub" link. Currently the link points to the 1.0.1 IDE source.
Paul
Thanks for sharing this.
I was looking for the code and only found old info. It made me think my knowledge of github is less than I thought. 8)
Best regards
Jantje
There's a very interesting 14 pin Ethernet RMII connector on the schematic, which I can't seem to locate anywhere in the photo. An ethernet shield using the RMII interface would be pretty nice (with a good library), rather than the W5100's rather inefficient SPI-based protocol.
I also noticed there's a new 4 pin debug header with nice, large 0.1 inch spacing, and the (way too small) 10 pin ARM debug is on the schematic, but not populated in the photo.
The 16U2 is no big surprise, but it's nice to see it controls both the erase and reset pins. Presumably it'll have slightly different firmware than the Uno version, to sequence the erase pin?
Something I didn't see on the schematic or in the photo is the Atmel dataflash chip that was present on the developer beta test boards. I guess it's safe to say that didn't make it to the final design?
These aren't urgent questions... just me thinking out loud about initial impressions seeing the schematic and a high-res photo for the very first time.
Well, for 39.99 I couldn't resist. Just put one on order - site is showing them on backorder. Hopefully it won't be too long. Thanks for the info guys.
Graynomad:
How about a couple of URLs, because when I go to "mouser" I wind up at au.mouser.com, maybe pico gets us.mouser.com or something.
Rob
The price has went up since the day of the announcement. It was 36.49 USD according to my e-mail receipt. Hope they don't raise the price I have to pay after the fact.
The price has went up since the day of the announcement. It was 36.49 USD according to my e-mail receipt. Hope they don't raise the price I have to pay after the fact.
That link redirects me to mouser.be, price there is €40.36. And that is without tax, so I must add another 21% + shipping.
Is there a way to get around the price problem by having someone from the USA buy then ship to you or is it just the way the currencies work out? I am thinking it probably won't help but, it is a thought.