So, I've got a brand new 328P-PU running on a mini breadboard. I've successfully burnt the 16Mhz Arduino bootloader and I've managed to upload the Blink sketch fine by doing the manual reset. I'm using a Prolific PL2303 based USB>Serial board and it has only 3v3, Vcc, RX, TX, Gnd connections. On an…

ATMega 328P-PU on Breadboard with PL2303 USB>Serial

CrossRoads December 17, 2012, 12:13am 4

Use some flux, don't overdo it with solder. Good luck!

Topic		Replies	Views
Breadboard atmega328 Upload sketch - not in sync - CP2102 usb to serial Microcontrollers	9	2231	May 6, 2021
PL2303HX programmer not responding Microcontrollers	7	3351	May 6, 2021
Uploading sketches to a standalone arduino uno on a bread board Microcontrollers	5	1659	May 6, 2021
ft232 breakout board (newbie) Interfacing	7	2383	May 6, 2021
Prolems programming minimalist UNO Microcontrollers	5	1692	May 6, 2021