sorry for being dense.. (Im trying though!) lol
ok..
well the green wire/trace in the pic IS the trace that goes to the PIC chip.. (pin 15 to be exact)
and from the pic.. that green line IS going to the 10k pot?
everything on the breadboard has the same GND rails?
I dont know what this means: "This circuit must be connected via an isolation capacitor."
So Im still not clear on what I need to do to fix it?
I need to put a 10uF cap on the same line/trace (green) in the diagram and connect it to GND?
is that what your saying?
thanks