oh and i have sensor shield v5.0 to maybe its possible to connect that lcd to that shield !?
can someone please help me with this its my first arduino and i have no idea what to do
It looks like the controller has an I2C and SPI interface mode, but that is not enabled on your LCD. However, there is an SPI interface to the SD card and Touchscreen as well as CS for the display being brought out. Would have been so much simpler if they had just made it a common SPI bus with individual CS lines for the display, SD, and touchscreen.
The SPI mode of the controller is set by setting the IB pins high or low. I would investigate modifying the circuit if I were you. I couldn't advise you directly what to do because the pictures do not show what I would need to see, but first find if the IB pins are brought out somewhere so that you can change them to SPI mode, then look to see if the SCLK, DI, and DO lines are brought out somewhere (probably share a DB pin) Then connect them all together for a single SPI bus, and use the CS lines to pick which devices you are communicating with. 6 lines total would give you access to an SD card, LCD, and touchscreen.
Otherwise, you are not going to have enough IO on the Uno to control that screen. Well, at least not without using latches.
OP, there are TFT screens that are plug and play, and arduino compatible, why didn't you get one of those? The SD card slot is for a micro though, not the regular one like you have.
HazardsMind:
Your right, I was thinking of something else.
OP, there are TFT screens that are plug and play, and arduino compatible, why didn't you get one of those? The SD card slot is for a micro though, not the regular one like you have.
can u give me some of the models of thous tft screens ? its just im searching for some tft screen ho don't take all the pints ! or maybe there is some witch one i could just connect to my sensor shield v 5.0 !