Due to conflicting information, there is a good chance i connected one of these up wrong, switching Gnd and 5v. Now i can't seem to get it to work. Does that mean its fried? And is there a way to test this? Thanks. FTL [image]

433mhz Receiver

system February 15, 2013, 2:12pm 10

Do you have a flat bed scanner, perhaps that can make a good scan/photo.

Topic		Replies	Views
Problem powering my 433mhz RF transmitter from my Arduinos 5v pin General Electronics	18	6144	May 6, 2021
433MHz RX/TX question, Manchester encoding Networking, Protocols, and Devices	20	18714	May 6, 2021
RF 433MHz Transmitter/Receiver not working? Networking, Protocols, and Devices	8	16106	May 6, 2021
433Mhz Transmitter/Receiver not working ? Networking, Protocols, and Devices	6	3508	May 6, 2021
Receiving Data from an 433Mhz RF module Networking, Protocols, and Devices	6	1681	May 6, 2021