Go Down

Topic: Cannot upload onto Uno (Read 120 times) previous topic - next topic

Djkis011

Nov 30, 2016, 01:59 pm Last Edit: Nov 30, 2016, 02:14 pm by Djkis011
Hi Everyone
Im new at this, but trying to learn, been trying to get this right now for hours but cant figure it out.

Im trying to load a sketch for Cayenne onto my Uno. But Im constantly getting this error
Can anyone help?

Below is error

Arduino: 1.6.9 (Linux), Board: "Arduino/Genuino Uno"

In file included from /home/dan/sketchbook/libraries/Cayenne/BlynkSimpleWildFire.h:14:0,
                 from /home/dan/sketchbook/sketch_nov30a/sketch_nov30a.ino:1:
/home/dan/sketchbook/libraries/Cayenne/Adapters/BlynkWildFire.h:27:29: fatal error: WildFire_CC3000.h: No such file or directory
 #include <WildFire_CC3000.h>
                             ^
compilation terminated.
exit status 1
Error compiling for board Arduino/Genuino Uno.




CrossRoads

Start simple:
Do you have WildFire_CC3000.h  in the libraries folder?
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

pert

Please install the WildFire_CC3000 library:

Djkis011

Hi Guys

Thanks for the response.
So I did as you said and added the WildFire_CC3000 library.

But then I get this error.


vrdude: stk500_paged_load(): (a) protocol error, expect=0x14, resp=0x18
avrdude: stk500_cmd(): programmer is out of sync
avr_read(): error reading address 0x0000
    read operation not supported for memory "flash"
avrdude: failed to read all of flash memory, rc=-2
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0xc0

Go Up