I am trying to use my serial port in the Arduino IDE to set the IP protocol on my Arduino Wifly shield. When I go to enter "$$$" to place the serial port into command mode, nothing happens. Any thoughts?

Serial Port will not go into command mode after entering $$$

system December 5, 2012, 12:11am 12

Also, I'm using IDE 0022. Not sure if that helps at all.

Topic		Replies	Views
WiFly Configuration Process - No response to $$$ Networking, Protocols, and Devices	5	1733	May 6, 2021
Can't get Wifly RN-XV into command mode Networking, Protocols, and Devices	12	4987	May 6, 2021
Lilypad + Wifly Interfacing	2	1101	May 6, 2021
Getting My WiFly Going Programming Questions	6	2024	May 5, 2021
WiFlyHQ cant connect with any examples Networking, Protocols, and Devices	1	972	May 6, 2021