I think I partially burnt my 328 from the MintDuino kit. It's still programmed to run the example Blink sketch, but when I swap it into my UNO R3 board it refuses to accept a new program though it still runs the original Blink sketch. I uploaded the sketch to my good 328 and watched the Rx and Tx L…

oops, partial toast

Coding_Badly January 22, 2013, 9:10am 2

Which bootloader did you install on the MintDuino processor?

Topic		Replies	Views
Drop in chip is not letting me upload sketches but is running fine IDE 1.x	4	947	May 5, 2021
Question about ATMEGA 328 behavior IDE 1.x	6	1595	May 5, 2021
sketch uploads, runs then will not start on reset Programming Questions	3	1539	May 5, 2021
Bootloading blank 328p chip issues Microcontrollers	10	2074	May 6, 2021
Mintrontics Mintduino chip won't program (MOVED) Microcontrollers	8	1678	May 6, 2021