Hola, estoy intentando entender la función millis, lo máximo que he conseguido es un retardo en la lectura de un sensor de temperatura lm35 y nada mas.
No entiendo muy bien el funcionamiento, ahora con un sensor dht11 intento hacer que si la humedad es menor de un valor, se active un rele, hasta aquí funciona, el problema lo tengo cuando intento hacer un temporizador con millis de 10 segundos para que lo desconecte, algo así, si HUMY_RELAY,HIGH realiza intervalo y HUMY_RELAY, LOW.
Me pueden explicar , gracias.
// Example testing sketch for various DHT humidity/temperature sensors
// Written by ladyada, public domain
#include "DHT.h"
#define DHTPIN 22 // what pin we're connected to
#define TEMP_RELAY 6
#define HUMY_RELAY 13
// Uncomment whatever type you're using!
#define DHTTYPE DHT11 // DHT 11
//#define DHTTYPE DHT22 // DHT 22 (AM2302)
//#define DHTTYPE DHT21 // DHT 21 (AM2301)
// Connect pin 1 (on the left) of the sensor to +5V
// Connect pin 2 of the sensor to whatever your DHTPIN is
// Connect pin 4 (on the right) of the sensor to GROUND
// Connect a 10K resistor from pin 2 (data) to pin 1 (power) of the sensor
DHT dht(DHTPIN, DHTTYPE);
void setup() {
Serial.begin(9600);
Serial.println("DHTxx test!");
pinMode(TEMP_RELAY, OUTPUT);
pinMode(HUMY_RELAY, OUTPUT);
digitalWrite(TEMP_RELAY, LOW);
digitalWrite(HUMY_RELAY, HIGH);
dht.begin();
}
static int relayTempVal = 0;
static int relayHumyVal = 0;
void loop() {
// Reading temperature or humidity takes about 250 milliseconds!
// Sensor readings may also be up to 2 seconds 'old' (its a very slow sensor)
float h = dht.readHumidity();
float t = dht.readTemperature();
// check if returns are valid, if they are NaN (not a number) then something went wrong!
if (isnan(t) || isnan(h)) {
Serial.println("Failed to read from DHT");
} else {
Serial.print("Humidity: ");
Serial.print(h);
Serial.print(" %\t");
Serial.print("Temperature: ");
Serial.print(t);
Serial.println(" *C");
if ( t < 27 ) {
digitalWrite(TEMP_RELAY, HIGH);
relayTempVal = 1;
} else {
digitalWrite(TEMP_RELAY, LOW);
relayTempVal = 0;
}
if ( h < 60 ) {
digitalWrite(HUMY_RELAY,HIGH);
relayHumyVal = 1;
} else {
digitalWrite(HUMY_RELAY, LOW);
relayHumyVal = 0;
}
Serial.print("Calefactor: ");
Serial.print(relayTempVal);
Serial.print(" \t");
Serial.print("Humidificador: ");
Serial.print(relayHumyVal);
Serial.print(" \t");
}
}