Go Down

Topic: Port Problems (Read 147 times) previous topic - next topic

Prateek18

Port not detecting after updating arduino ide to 1.6.10.
Even re-installed the software.

Prateek18

#1
Aug 03, 2016, 12:10 pm Last Edit: Aug 03, 2016, 02:37 pm by Prateek18
Port not detecting after updating arduino ide to 1.6.10.
Even re-installed the software. plz help.....

kylefoster

Hi,

Is the correct port chosen in the device manager?:



I had the same issue when I installed mine recently.

Kyle

Robin2

Go back to the older version of the IDE?

...R
Two or three hours spent thinking and reading documentation solves most programming problems.

Gautham12

Hey guys, i am new to the arduino and i know some of the basics. I created a sketch and uploaded it until then when my arduino was plugged in the tx and rx LEDs were off and the L LED was blinking. I removed it from the power and the next day when i plugged it into my computer the L, TX, RX LEDs were constantly turned on and the computer was not recognising the board. I am worried.

Delta_G

Port not detecting after updating arduino ide to 1.6.10.
Even re-installed the software. plz help.....
The port master shouldn't be using Arduino.  Cargo ships are big dangerous things.  Those controls are probably best left to the commercial companies that specialize in that type of equipment.
If at first you don't succeed, up - home - sudo - enter.

Go Up