I’m trying to assemble the Arduino Ethernet Shield Rev. 6.
I’m having difficulty to locate the proper RJ45 connector with 10 pins.
I need help in order to specify the right connector.
Thanks
Eric V. Barreto.
I’m trying to assemble the Arduino Ethernet Shield Rev. 6.
I’m having difficulty to locate the proper RJ45 connector with 10 pins.
I need help in order to specify the right connector.
Thanks
Eric V. Barreto.
I don't think it's a 10pin jack on the "ethernet" side, but in order to implement the Power-over-Ethernet capability, the connector has to provide both a filtered signal output ("with magnetics") as well as a "raw" (rawer, anyway) output for the power. So it has more pins coming out than it has going in. Silvertel (who makes the PoE modual) has a list of compatible jacks here: http://www.silvertel.com/poe_magnetics.htm
I'm not sure which one the Arduino shield actually uses.