So I'm looking to add a touch screen to my project. I'm looking at this one http://www.adafruit.com/products/335
It says that you can add one of these http://www.digikey.com/product-detail/en/H3AAH-2006G/H3AAH-2006G-ND/1218466?cur=USD
But, Honestly, I'm not quiet sure how to achieve this, I want to keep all of my boards in an enclosure, and have this screen able to be remote accessed. Thanks for any clarification guys.
The pin headers on the display would "plug-in" to the cable instead of the breadboard. Pin headers would then be used on a circuit card (or breadboard) to connect the cable.