Arduino Forum

Products => MKR Boards => MKR1000 => Topic started by: raghun6 on Dec 11, 2017, 12:14 pm

Title: MKR1000 reset issue
Post by: raghun6 on Dec 11, 2017, 12:14 pm
Hi all,
I recently bought ARDUINO MKR1000 WIFI board. The board works fine when I load a sketch and starts running the program and displays the data strings on the Serial Monitor. The issue is when I reset the board   I do  not see any debug messages on the serial port. Everytime if I had to run the program I have upload the sketch. The example I am using for this is SimpleWifiWebServer from the wifi101 library.

But the reset of the board work for a simple blink project, even when I reset the board the LED start blinking.

Thanks
Raghu Ravi

Title: Re: MKR1000 reset issue
Post by: Bjain on Dec 21, 2017, 08:04 am
You should try by closing the serial monitor before reset.
After reset, reopen the serial monitor to get the data on serial monitor.
Title: Re: MKR1000 reset issue
Post by: ballscrewbob on Dec 21, 2017, 02:17 pm
@raghun6

You need to post the sketch that does not work but please use code tags to do so ( </> ).

Title: Re: MKR1000 reset issue
Post by: sandeepmistry on Dec 21, 2017, 04:22 pm
Hi @raghun6,

As @Bjain mentioned above you'll have to close and re-open the serial monitor as the board uses Native USB for the Serial when reset the port is disconnected from the PC.