Dear cyclegadget,
Thanks for help
Or I am in wrong department .I will come correct
But very few post on that 
Tx
duinopad

What is the problem?  (48)

Could you please find the my post (35).
Thanks in advance

You have been advised. That error is not being generated from the Arduino IDE program, but rather it's an error from some 3rd party PC based AVR simulator program. There very well be no one on this forum that has used that simulator so it's hard to help you with whatever that error means. Have you attempted to contact the supplier of the simulator program about the error you are getting?

Lefty

Dear Lefty,
Thanks for the reply

I simulated sample code provided by Arduino (Blink), so it is running very well, then I wrote the same program and compiled and load the sketch to the same simulator, unfortunately the above error was  encountered .

What will be the next,
Please help
Thanks in advance

Dear All,
46 post already pass on this thread but my problem remaining unchanged

Please advice

Can I have the solution for my last question

Dear All,
1.I wrote the program as attached picture and compiled well

2.sketch was generated as attached picture
3.Then I uploaded sketch file to Arduino simulator
4 The error message was generated as attached picture
Please advice
 

Dear dxw00d ,
Thanks for reply
Could you please Let me know the different between sketch and HEX file
Thanks in advance

Dear cyclegadget,

Thanks for reply

I downloaded Simulator for Arduino v0.98 and installed. Then I downloaded  Arduino IDE and wrote the following program

Code:

void setup (){
pinMode (13, OUTPUT);
}
void loop(){
digitalWrite(13, HIGH);
delay(1000);
digitalWrite(13, LOW);
delay(1000);
}

Please advice how may I load the compiled file (HEX) to simulator. where the HEX file is generated

Please advice
Thanks in advance


 

Dear All,
Thank you so much for all for the reply
I am sorry for got long delay come back to this tropic. Please accept my apologizes any inconvenience case

But I did not see a relabel software simulator for Arduino that Newbie can practice before buy the hardware   
Please advice
Thank in advance

Dear All,
I am new for Arduino
It would be greatly appreciated, if someone can give me a Arduino supportive software Simulator and It will be much helpful to me to start Arduino Programming
Please Help
Thanks in advance

Dear cyclegadget
Thank you very much for reply

It would be much appreciated, if you can prove that quicker writhing code using example like LED blinking
Thanks in advance

In Assembly using PIC

loop
bsf portb,1
call  delay
bcf  portb,1
call delay
goto loop
 

Dear All
I am new for arduino
I would like to know, What is the advantage Arduino than AVR.if both use same chips
Thanks in advance