Show Posts
Pages: [1]
1  Using Arduino / Project Guidance / Re: RC servo control on: February 10, 2013, 12:44:56 pm
Ok. Thanks. I'll have a look.
2  Using Arduino / Project Guidance / Re: RC servo control on: February 10, 2013, 12:30:09 pm
That has worked fine. Thanks for that.
Just another quick question...if you want to put a delay in between the 'loops' can you? So it runs through a sequence, then pauses for some seconds...?
Thanks.
3  Using Arduino / Project Guidance / Re: RC servo control on: February 10, 2013, 08:48:25 am
That's verified. Thanks I'll give it a go.
4  Using Arduino / Project Guidance / Re: RC servo control on: February 10, 2013, 08:25:47 am
Thank you JIMBOZA,
That looks just what I need....only I can't get it to 'verify' in the Arduino software. Any chance you could have a quick loo and see what the problem is? Thanks again for your time and knowledge.
5  Using Arduino / Project Guidance / Re: RC servo control on: February 10, 2013, 06:46:48 am
Thanks for the reply. I'm sorry but I have not got any code yet (except the 180 degree sweep from the library). Could you explain how to alter this code...or give me an example of say..0 to 180 degrees sweep with a 5 second pause at the 180, then to 90 with a 3 sec delay..then back to 0. I reckon I will then be able to make my own adjustments to the code to get the effect I'm after. Thanks.
6  Using Arduino / Project Guidance / RC servo control on: February 08, 2013, 09:06:01 am
Hello, I am completely new to Arduino. I am trying to control a RC hobby servo with Arduino. I have pasted in the 180 sweep available from the library and it works fine. However, I am wanting the servo to sweep from various angles and at various speeds. I have modified the code so that it does this....but I also want it to pause for a few seconds every now and again so it is not constantly moving. I can't seem to get it to do this..any ideas? Thanks.
7  Forum 2005-2010 (read only) / Troubleshooting / auto tracking on: April 17, 2009, 10:41:54 am
Hello. I'm totally new to arduino and have just got my first board. Can anyone help me...I'm trying to use it to control a servo that can track a moving object ( it doesn't have to be to accurate). I was going to use PIR sensors and get them to trigger the movement..... Any ideas?
Cheers.
8  Forum 2005-2010 (read only) / Development / auto tracking on: April 17, 2009, 10:40:25 am
Hello. I'm totally new to arduino and have just got my first board. Can anyone help me...I'm trying to use it to control a servo that can track a moving object ( it doesn't have to be to accurate). I was going to use PIR sensors and get them to trigger the movement..... Any ideas?
Cheers.
9  Forum 2005-2010 (read only) / Interfacing / Re: Using digital outputs to switch 24v DC on: May 01, 2009, 05:24:37 am
Would this system work with 12V at about 5 A.? I want to control some wiper motors with the arduino board.
Pages: [1]