Show Posts
Pages: [1]
1  Community / Gigs and Collaborations / Re: Looking to hire programmer to help with project in Santa Clara CA on: November 06, 2012, 10:38:38 am
Sorry about putting this under the wrong topic.  Thanks for moving it.
2  Community / Gigs and Collaborations / Looking to hire programmer to help with project in Santa Clara CA on: November 06, 2012, 09:30:16 am
Hello,

I am looking for someone near Santa Clara, CA to help write the program/sketch for a project using an Arduino UNO board, LCD, motor, analog & digital inputs, and Arduino WIFI Shield.  If you are available please reply and we can work out how to get in contact.

Thank you,

John
3  Using Arduino / Project Guidance / New Project w/UNO, Motor Shield Kit, Xbee Adapter, Blue LCD Kit, and Analog Temp on: May 29, 2012, 06:05:22 pm
I would like to ask if the I can add a Motor Shield Kit, a Blue 16x2 LCD Kit from adafruit, an XBee Adater Kit, and an TMP36 Analog Temp Sensor to an Uno Board.  The concept is for a device that can adjust the position of a (Tower Pro SG-5010) servo based on the temp sensor.  The unit will need to display the actual temp and setpoint on the LCD as well as be able to broadcast the values through the wireless xmitter so I can ping it with my laptop.

I'm new to controls and using Arduino products.  My first question is if I can connnect the motor, LCD, and wireless boards (shields) to one Uno?

Second would be If there are any examples, or sketches for all or part of this project.

Thank you,

John
4  Using Arduino / Project Guidance / Re: Temp Controller Concept-NEWBY LOOKING FOR RECOMMENDATIONS- on: May 17, 2012, 10:48:05 am
Thank you for the advice.  I will look into the products mentioned.
5  Using Arduino / Project Guidance / Temp Controller Concept-NEWBY LOOKING FOR RECOMMENDATIONS- on: May 16, 2012, 04:42:43 pm
Hi,

I am developing a concept of a temp controller device that takes an analog input from a temp sensor input and setpoint from a UI then turns the heat source knob with a DC Motor and potentiometer as the feedback/encoder using a PID (or portion of) control to maintain the setpoint.

My question(s) are if the Arduio products can do this and if anyone has any examples or recommendations of all or protions of the project hardware and program. I am not an EE or programmer, so I will be learning on the fly.  My skills are mech design with some knowledge of control systems, but not at this level.

Any help would be appreciated.

Thank you,
buckmartin
Pages: [1]