Show Posts
Pages: [1]
1  Using Arduino / Displays / Re: U8glib: Graphics Lib for LCDs and OLEDs on: January 22, 2014, 01:41:54 pm
Have anyone tried to use this lib with Nokia 7110 display? It doesn't work for me and I've tried few configurations for different so-called compatible displays, but didn't work. I need help because I have 3 lcd displays collected from some 7110 phones. Thanks!
2  Development / Other Software Development / Re: [MOD] Arduino Enhanced Release 1.0.5 for Windows (installer, drivers, etc) +SRC on: January 12, 2014, 08:12:04 am
I don't know if someone had this idea, but can anyone make a pack with all important libraries from GitHub or something like that? Sometimes is a pain in the a$s to find a pretty common library on internet. Anyways, really really nice job. I'm using this Enhanced Release for about one month and I don't want to get back to the old original IDE. Oh, and can you add support for atmega644p and 1280p? Thanks! Good luck!
3  Using Arduino / Displays / Menu on PCD8544 controlled by IR remote on: February 15, 2013, 05:26:00 am
Hello guys! I have a problem in interfacing a PCD8544 display with an IR remote. The actual problem is, I want to control some sort of menu on the display using the IR remote control instead of those 4 physical buttons that are supposed to be connected to digital pins of Arduino. When Arduino is receiving the correct code from IR it should emulate the physical pushed button as HIGH value. How should I do this? I'm using this sketch for the menu.

Please help me! I'm a bit n00by in programing so I need your advices. Thanks!
4  Using Arduino / LEDs and Multiplexing / Re: 4 x 7 segments LED display + Arduino Uno on: May 24, 2012, 11:25:34 am
i've already done that but it's killing me inside...i'll try again tomorrow smiley-wink and about the resistor, i've did the test using a 270ohm resistor and everything was just fine. thanks for reply and i'll be back with news tomorrow smiley cheers
5  Using Arduino / LEDs and Multiplexing / 4 x 7 segments LED display + Arduino Uno on: May 24, 2012, 04:54:14 am
Hey guys! I want to make a small project using a 4 x 7segments LED display like this with this pin configuration powered by an Arduino Uno. The problem is I need some ideas how to connect the display to a multiplexor then to arduino and what type of multiplexor should i use. The display is a recovered part from an old desk FM radio with clock. Thanks!
Pages: [1]