Site should be 95% operational.  If your experiencing a lot of bugs still, clean the cache and cookies.

Amazing, might just have to purchase this robot.  Usually I build my own chassis and hardware, but this looks amazing.  Very fast little bot!

@ codlink - thanks, that is a pitty they don't allow internal cutouts. I guess they are fine with irregular shapes though so my design should be OK? I best start renaming the parts then

I do remember some people saying they will cut along the dimension lines, but I have have also heard of irregular boards coming back un-cut.  I would email them to make sure.  I forget their direct email, but you use the contact us page.

Watched a few minutes of the first video and I approve.  ie, no annoying music.. 

Now if you can just get the beginners to watch them.   

I've been getting this too.  I am having to keep refreshing to see my posts.  It's funny it says to report to admin, but there is no link or button or...

Also the "Mark Read" isn't working very efficiently.  I have to click it 3 or 4 times to get it to work right.  First time I click all the posts are set to new, click again and some of them are read, then it takes 1 or 2 more clicks to get them as read.

I have also seen if there are images in a post, I click on one and it says I don't have permission to view it.  I refresh and then I can view it.

We need a dedicated bugs thread.  I have seen more than these that are listed.  They just don't happen as often to annoy me.  I know you guys behind the scenes are working on it.  Take your time and do it right.  Thanks for the hard work.

PS - The image attached is what I get when I post or even open a topic.  I have to keep refreshing for it to come up.  The second image is when I try to view the first image.

You're going to have to rename them by hand.

No, Itead doesn't do cut-outs.  It's specified in the their directions.

What code?  Did you use EasyVR Commander to generate the code?

All of the links in a Google search are 404.  Expect a ton of people asking questions..

Email notification isn't working.

Quick edit icon is missing.

What pins is the jumper on?

Code:

delay(500); // waits 25ms for the servo to reach the position

Useless comments.  Your waiting half a second.  During that time, the Arduino does absolutely nothing.

On all the kits I have seen, there were instructions.  But, never-the-less, http://billwaa.wordpress.com/2012/06/06/arduino-l298-dual-h-bridge-motor-driver/

That site even gives you the code.. 

NOTE: The board on that site is not the same as yours.  But if you look closely, they both have the same pinouts.  BTW, I found this on the first page Google searching "arduino l298." 

I agree that a pneumatic system would be the quietest.  Google would be your best bet.

I have a pneumatic system moving the arms of a humanoid robot.  The air cylinders come in many different sizes.  Ebay has tons of them.  Arduino can control the system through relays.

How can I use this sensor?

You can wire it to the Mega using jumper wires.

That vague answer was a response to your vague question.  First we need to know what isn't working.  What is the serial monitor printing?  And, possibly how you have it wired.

Holy cow, those are expensive.  Go to Ebay and pay half the price..

then connect all to a 9v battery

I hope that 9V is not one out of a smoke detector.  They will be good for about a min at most, then you can throw it away.