Show Posts
Pages: [1]
1  Using Arduino / Installation & Troubleshooting / Re: stk500_recv(): programmer is not responding on: November 14, 2012, 06:14:38 pm
snip
Primary focus is on the black square or rectangle to the right of the USB socket.  If it is rectangular with pins on both sides, it is FTDI.  If it is a square it is either an Atmega8u2 or Atmega16u2.

My Uno looks like


The chip to the right of the USB socket is square, so I don't need the FTDI Drivers, I'm assuming.

Thanks for the continued assistance.
2  Using Arduino / Installation & Troubleshooting / Re: stk500_recv(): programmer is not responding on: October 30, 2012, 04:20:29 pm
snip

Are you sure you have an Atemga8/16u2 and not an FTDI chip?  If you have an FTDI chip you will need to download:
http://www.ftdichip.com/Drivers/VCP/MacOSX/FTDIUSBSerialDriver_v2_2_14.dmg

I have no idea what Atmega and FTDI are, but the box that the Uno board came in says Microcontroller: ATMEGA328P.  Is that any help?
3  Using Arduino / Installation & Troubleshooting / Re: stk500_recv(): programmer is not responding on: October 26, 2012, 02:50:04 pm
So the "A new network interface has been detect" box did not come up after plugging in the Uno?

You will have to bear with me until a real Mac user comes by smiley-wink

No, no dialog box appears when I plug in the Uno.

Does "Network Preferences" show the Uno anywhere?  If the driver enumerates the Atmega8/16u2 it should show up as a device on the network.  If so, what kind of properties does it have?

Network Preferences shows a USB Modem, Not Configured.  I do not believe that this is the Uno, however, because the entry persists even without the Uno plugged in.

I am fairly sure the Arduino application detects the Uno board, because when I plug the Uno board in, there are two more selections to choose from under Tools > Serial Port.

Thanks for the replies!
4  Using Arduino / Installation & Troubleshooting / Re: stk500_recv(): programmer is not responding on: October 24, 2012, 07:27:23 pm
I've checked the troubleshooting guide, and I've searched the forums but I have not found a solution to this.  Any hints?
5  Using Arduino / Installation & Troubleshooting / Re: stk500_recv(): programmer is not responding on: October 18, 2012, 05:08:19 pm
I have the exact same error, but I have even fewer complications so I have no idea how I could have messed anything up  smiley-eek.

Arduino Uno
Running version 1.0.1

Mac OS X Version 10.7.4
Serial Port: /dev/tty.usbmodem1d11


Uno means no drivers are necessary, according to the setup instructions.

I just plugged the board in for the first time.  I got a green LED, so I ran the Arduino application, loaded Blink, and got the error in this thread's title.  The RX Led blinked 3 times but that's all I got.
Pages: [1]