Show Posts
Pages: [1]
1  Using Arduino / Programming Questions / Re: Reading Serial Data from Accelerometer on: November 08, 2012, 02:59:03 pm
Thanks everyone for their input.
I've set up the Atomic IMU through it's own configurator running a C program.
I've redone the code and now it looks like this:

Would You please explain; how did You set up the Atomic IMU through it's own configurator?

I'm sorry but I couldn't find how to open the IMU's configuration page/mode for 2 days!! Hell yeah! For two days.. smiley
2  Using Arduino / Sensors / Connecting an Atomic 6DOF IMU to ARDUINO Uno on: November 08, 2012, 08:41:05 am
Dear All,

I've just bought an Atomic 6DOF IMU sensor from Sparkfun and also an Arduino Uno Board.

I want to connect this IMU to my Arduino and get the raw data, but I couldn't find an instruction about how to connect them.

My first question; Is Arduino UNO capable to get data from this IMU?

If it's possible;

There are six pins on my IMU sensor;

1- GND (for ground)
2- Bulk (no name)
3- VCC
4- RXD
5- TXD
6- OTR

How should I connect these pins onto the Arduino? To ANALOG IN sockets or where?

Thank You all in advance for Your help!
3  Using Arduino / Sensors / Re: Laser Height Difference Sensor on: November 04, 2012, 05:16:40 pm
Thanks for the reply Chagrin. Well, yes. I want to know that if there is a laser receiver component for land surveying, for measuring the level differences and so on..

5 cm is really small, it's not enough..

4  Using Arduino / Sensors / Laser Height Difference Sensor on: November 03, 2012, 08:41:36 pm
Dear All, I searched all the forum but couldn't find any "laser" sensor for calculating the difference of height from a reference point.

Is there any "laser" receiver component which shows the +,- difference values from a predefined reference point?
5  Using Arduino / Project Guidance / Re: Sensing absolute height on: November 03, 2012, 07:06:59 pm
I'm working on a project exactly equal to this. Problem is; "getting a data" from this laser receiver and also process it via Arduino.

 
6  Using Arduino / Project Guidance / Re: Question About Pneumatic Cylinder Control Project on: November 03, 2012, 06:08:35 pm
Thanks for the reply Peter!

It's moving. I will check the drones for the math.
7  Using Arduino / Project Guidance / Question About Pneumatic Cylinder Control Project on: November 03, 2012, 04:33:33 am
Dear All,

I want to detect the changes of the surface level while moving and to process&forward this data to my pneumatic cylinders which will be expected to make the equal-inverse movement of the change. I think I should use an IMO or some board which has accelerometer and gyro sensors inside.

I'm a pure mechanic and a newbie to arduino electronics. I set up the pneumatic schema&system but would You please suggest me which model or type of electronic equipments should I use in my project.

Thank You in advance for Your help.   
Pages: [1]