Show Posts
Pages: [1]
1  Using Arduino / LEDs and Multiplexing / Re: My RGB LED Stairs Illumination video on: November 11, 2012, 03:37:47 pm
I can't remember the exact spec of the lights we installed but it was something similar to this I believe, http://www.tryka.co.uk/Module1in-ground.htm  .. i will try and find the exact one and post it later.

The stairs are solid concrete, so the lights were installed while they were re-tiled. A cable connects the left to the right, and then each stair runs down behind the skirting board on the right to a cupboard that we built to hold the 27 drivers and DMX controllers. It then integrates into the rest of the LED controlled lights and is controlled by a programme called show magic.
2  Using Arduino / LEDs and Multiplexing / Re: My RGB LED Stairs Illumination video on: November 08, 2012, 06:46:27 pm
Hi,

I have a similar setup, although perhaps a bit more comercially bought than what you seem to have made.. you can take a look here..



My question is though, what software do you use to programme and control the lights?

We currently use show magic and its a absolute headache to programme in my opinion!

Thanks

Calum
Pages: [1]