Show Posts
Pages: [1]
1  Using Arduino / Networking, Protocols, and Devices / Re: Controll two DC motors over wifi with Wifly on: December 11, 2012, 08:31:59 pm
Jaks13,

looking at the wifly schematic you should be able to re-assign the motor pins in your sketch to anything from D2 - D6 and it should work.

Hope this helps ...and thanks for reporting your progress !
Build_it_Bob
2  Using Arduino / Networking, Protocols, and Devices / Re: Sudden unreliability with my network-enabled Arduino project on: December 11, 2012, 07:44:35 pm
Looking at the picture the screw heads that you used may be shorting traces on the circuit board. This would have taken time to wear through the silk screen . remove the screws and use a wire tie ( or plastic stand offs ) to hold the board and re-test. if it works reliably , you can use plastic standoffs to fasten the board securely. I use #4-40 standoffs with a small #4 lock washer and the screw heads don't touch any traces on the board.

Hope this helps !
Build_it_Bob 
3  Using Arduino / Networking, Protocols, and Devices / Re: Mega 2560+ethernet shield and sensor on: December 11, 2012, 07:27:24 pm
This looks very interesting...I wish you well with your venture and will keep it in mind if I have any application for this .
Build_it_Bob
4  Topics / Home Automation and Networked Objects / Re: Arduino Controller android app on: December 08, 2012, 07:25:49 pm
Marque ,
  Wow , I love the app ...I sent an email to you as well , but i also wanted to say THANK YOU! on the forum. I am now able to use your app to control my home audio system . I tried the Android tablet in my garage + outside and it works great ! I activated more buttons in the code and found it very straight forward . I have other code that I want to integrate as well as some low voltage lighting.
  Keep up the great work and MANY THANKS on a job well done!
Build_it_Bob   
Pages: [1]