Show Posts
Pages: [1]
1  Products / Arduino Due / Re: TFT library compatible with Due? on: December 15, 2012, 01:40:27 pm
I am curious what I would need to modify in the library to get my 8 Bit LCD running properly.

Hi.

I've included code for 8 bit mode.

Replace (doing backup of your current file) the HW_ARM.h file in your library with the one attached with your IDE closed.

I don't have a display to test it, but should work, try it! smiley-wink

Regards,

Joao

Ok, replaced the file and modified the demo code with this:

UTFT myGLCD(ITDB28,59,58,57,56);

Where 59-56 are the Due hardware pins corresponding to RST,CS,WR,RS

Unfortunately this did not work and I am still left with only a backlight on my LCD.
2  Products / Arduino Due / Re: TFT library compatible with Due? on: December 14, 2012, 11:52:27 pm
I am curious what I would need to modify in the library to get my 8 Bit LCD running properly.

Hi.

I've included code for 8 bit mode.

Replace (doing backup of your current file) the HW_ARM.h file in your library with the one attached with your IDE closed.

I don't have a display to test it, but should work, try it! smiley-wink

Regards,

Joao

Thank you, I will give this a try and let you know how it goes.
3  Products / Arduino Due / Re: TFT library compatible with Due? on: December 13, 2012, 11:02:19 am
I'm sorry, there seems to be a mixup.. I was replying to a post that now appears to be gone (it was regarding a shield that simplified wiring a TFT to a MEGA). smiley-sad

Ah, no problem smiley
4  Products / Arduino Due / Re: TFT library compatible with Due? on: December 13, 2012, 10:51:09 am
This should work just fine, it's just that the level converters will be redundant since the Due's logic is already 3.3V. It should be OK though.


Oh, I'm not worried about the board's electrical compatibility, its just that the current Due modifications to the UTFT Library only work with the 16 bit models of LCD. I am curious what I would need to modify in the library to get my 8 Bit LCD running properly.
5  Products / Arduino Due / Using the 8 bit ITDB28 model on: December 12, 2012, 10:25:03 pm
Hello Folks,
I have the ITDB28 (2.8" with Touchscreen, Uno Shield pin layout). Here is the product link if anyone is curious:
http://imall.iteadstudio.com/im120417020.html

 I would like to use it with my Due, unfortunately the Due modifications I have run across only work with the 16bit models. Could anyone give me some pointers for getting it running in 8 bit mode?

Much appreciated!
Pages: [1]