Show Posts
Pages: [1]
1  Products / Arduino Due / Re: Is my board dead on: December 25, 2012, 03:29:16 pm
Its probably dead, I have no clue what happened. I think something may have shorted or it was defective... Never even programmed it : (

All the pwm pins are .6v lower than pin 13 and the regular digital io pins are 2.0 volts
2  Products / Arduino Due / Is my board dead on: December 25, 2012, 03:01:01 pm
I was trying to test a PS/2 mouse sensor, and I think that the way that the PCB was wired up I may have hooked up ground to 5v through only a resistor. Now I cannot get Windows to recognize a Due device, only the programming port. Am I toast? Also all the digital pins are outputing 3.3v...
Edit:(I checked the circuitry and there is a capacitor between ground and 5v which should block all current)

I havent even programmed it yet, and I held down the erase button to make sure that there is no program on it.

Ive gotten the arduino ide to recognize the com port, but when I try to program it says that there is no device on the port, and the ARM chip gets very hot
Pages: [1]