Show Posts
Pages: [1]
1  Using Arduino / Interfacing w/ Software on the Computer / Re: bluetooth on: February 13, 2013, 12:00:29 pm
Hey,

no I don't get a response smiley-confuse
2  Using Arduino / Interfacing w/ Software on the Computer / Re: bluetooth on: February 12, 2013, 12:12:53 pm
Hey,

my rfcomm.conf was commented out, so I edited it like yours, but it is still not working.
It looks like this:
Code:
rfcomm0 {
# Automatically bind the device at startup
bind yes;

# Bluetooth address of the device
device 00:12:11:12:06:48;

# RFCOMM channel for the connection
channel 1;

# Description of the connection
comment "arduino";
}
3  Using Arduino / Interfacing w/ Software on the Computer / Re: bluetooth on: February 06, 2013, 09:05:34 am
Hey,

when I enter: rfcomm
I get this information:
Code:
rfcomm0: 00:23:4D:E5:7F:0F -> 00:12:11:12:06:48 channel 1 connected [reuse-dlc tty-attached]
4  Using Arduino / Interfacing w/ Software on the Computer / Re: bluetooth on: January 28, 2013, 01:56:04 pm
Nobody?
5  Using Arduino / Interfacing w/ Software on the Computer / Re: bluetooth on: January 15, 2013, 03:50:23 am
Hey,

I used blueman to connect the shield to /dev/rfcomm0
Then I used cat /dev/rfcomm0 to listen and echo hello > /dev/rfcomm0 to send.
Serial.print("Hello") and Serial.write("Hello") don't make a difference.
6  Using Arduino / Interfacing w/ Software on the Computer / Re: bluetooth on: January 14, 2013, 12:17:15 pm
Hey,

thank you for your answer. I tried it with 38400 Baud, but nothing happened:-(
my switch is at DAT, when I set it on CMD I can't find the shield with my computer.

I also tried it with software serial:
Code:
#include <SoftwareSerial.h>
SoftwareSerial ss(6,7); //I set the jumper for rx to 6 and tx to 7
void setup()
{
  ss.begin(9600);
}
void loop()
{
  if(ss.available())
  {
     ss.write("Incomming");
  }
}
But this neither worked.
7  Using Arduino / Interfacing w/ Software on the Computer / Re: bluetooth on: January 13, 2013, 01:30:23 pm
I let them at the default position.

rx is at 0 and tx is at 1.
8  Using Arduino / Interfacing w/ Software on the Computer / bluetooth on: January 13, 2013, 12:55:40 pm
Hey,
I bought myselfe an arduino bluetooth shield. http://imall.iteadstudio.com/im120417010.html

I tried to communicate with my pc via the following code:
Code:
void setup()
{
  Serial.begin(9600);
}


void loop()
{
if (Serial.available())
  {
    Serial.write("Incomming");
  }
Serial.write("HELLO");
}

I had paired my pc with the arduino bluetooth and connected the bluetooth of my pc to /dev/rfcomm0

But I see no income and no outgoing. What am I doing wrong?
Pages: [1]