Loading...
  Show Posts
Pages: [1]
1  Using Arduino / Motors, Mechanics, and Power / Re: Help needed Arduino Uno R3 on: January 25, 2013, 06:13:52 pm
Thanks alot , let me try experimenting with your suggestions and see how far i can go then come back with a feedback.
2  Using Arduino / Motors, Mechanics, and Power / Re: Help needed Arduino Uno R3 on: January 24, 2013, 07:10:25 pm
Sorry for not being polite.
Both cards work with other sketches without any problem at all, works even with other sketches i have scavanged around internet, the reason i went for this code is that it has extended functions and mainly that it solves a bug i had with another sketch whereby the stepper sometimes disregards the direction change command. And if you check this code, it had the same problem initially.
3  Using Arduino / Motors, Mechanics, and Power / Re: Help needed Arduino Uno R3 on: January 24, 2013, 09:03:52 am
Still no help
4  Using Arduino / Motors, Mechanics, and Power / Re: Help needed Arduino Uno R3 on: January 23, 2013, 06:45:44 pm
Yes, the Arduino Power LED is on, notice that the code was written for Duemilanove, but experts say that it should work ok. Another info you need to know is that other sketches all work without any problem.
5  Using Arduino / Motors, Mechanics, and Power / Re: Help needed Arduino Uno R3 on: January 23, 2013, 06:34:15 pm
Have disconnected everything except the ground, when i remove the ground and run it over the serial monitor i get readings, but when i put the wire back it stops.
6  Using Arduino / Motors, Mechanics, and Power / Re: Help needed Arduino Uno R3 on: January 23, 2013, 06:06:33 pm
Here is the connection also borrowed from Daniels blog
7  Using Arduino / Motors, Mechanics, and Power / Re: Help needed Arduino Uno R3 on: January 23, 2013, 05:28:40 pm
No one willing to give a hand????
8  Using Arduino / Motors, Mechanics, and Power / Help needed Arduino Uno R3 on: January 23, 2013, 07:33:09 am
I'm new to Arduino and was trying to use a stepper with the EasyDriver, Im using a code i found here http://www.danielschweinert.com/resources/BLOG/stepperSingleChannel03.pde. The problem is whenever i connect the EasyDrive GND to the UNO GND the L-LED goes off, i'm very poor in programming and therefore cannot see what is wrong with the code, can someone help me find why the code is not working in my setup?
Pages: [1]