Show Posts
Pages: [1]
1  Using Arduino / Motors, Mechanics, and Power / Re: problem with servo on: February 09, 2013, 05:15:26 pm
Hey , i am facing a similar problem , i have given a 5volts (stepped down from 12 volts ) to the board , the 9g servo runs properly but i have a 60g avionic servo , if i connect it in the same way and try ,the servo starts once and then stops , also can someone explain the improper rotation with these servos , i am really out of ideas and a bit frustrated .( i used the library , sweep sketch )
Pages: [1]