Show Posts
Pages: [1]
1  Using Arduino / Installation & Troubleshooting / Re: uploading code on arduino uno on: March 27, 2013, 07:30:20 am
I got a new arduino with loopback test working but i m still getting
avrdude: stk500_getsync(): not in sync: resp=0x00
and on shift + upload i m getting
avrdude: usbdev_open(): did not find any USB device "usb"
2  Using Arduino / Installation & Troubleshooting / Re: uploading code on arduino uno on: March 11, 2013, 10:51:57 am
Can i get that fixed?
If yes tell me what to do?
3  Using Arduino / Installation & Troubleshooting / Loop Back Failure on: March 10, 2013, 12:56:20 pm
I did the loop back test. Did not get the letter i typed on the terminal. I could just see the Rx LED on when the key was pressed.
4  Using Arduino / Installation & Troubleshooting / Re: uploading code on arduino uno on: March 10, 2013, 12:53:37 pm
I m not getting the letters typed in the terminal. But i just see the Rx Led on when the key is pressed. So what should i do next?
Thanks a lot
5  Using Arduino / Installation & Troubleshooting / Re: uploading code on arduino uno on: March 09, 2013, 01:24:01 pm
Sorry can you tell me how to get the loopback results?
Thanks a lot
6  Using Arduino / Installation & Troubleshooting / Re: uploading code on arduino uno on: March 06, 2013, 02:41:55 am
I bought that from element14
It was working fine for a year but now i have this problem
Thanks a lot
7  Using Arduino / Installation & Troubleshooting / Re: uploading code on arduino uno on: March 04, 2013, 08:19:39 am
I have Arduino UNO from Italy. I m selecting the same board in the IDE.
Thanks a lot for your reply.
8  Using Arduino / Installation & Troubleshooting / Re: uploading code on arduino uno on: March 03, 2013, 01:51:17 pm
I used arduino 1.0.3 and not working for that also.
I tried shift + upload and it says:

avrdude: usbdev_open(): did not find any USB device "usb"

Thanks a lot  smiley
9  Using Arduino / Installation & Troubleshooting / Re: uploading code on arduino uno on: March 03, 2013, 12:42:53 pm
I have similar problem, i checked com port and board, every thing is proper.I even tried pressing reset before uploading nothing is working. I tried shift + upload and i got this:

avrdude: Version 5.4-arduino, compiled on Oct 11 2007 at 19:12:32
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/

         System wide configuration file is "D:\Softs\arduino-0023\hardware/tools/avr/etc/avrdude.conf"

         Using Port            : \\.\COM18
         Using Programmer      : stk500v1
         Overriding Baud Rate  : 115200
avrdude: ser_open(): setting dtr
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Send: 0 [30]   [20]
avrdude: Recv:
avrdude: stk500_getsync(): not in sync: resp=0x00
avrdude: Send: Q [51]   [20]
avrdude: Recv:
avrdude: stk500_disable(): protocol error, expect=0x14, resp=0x51

avrdude done.  Thank you.


Help me with this. Thanks a lot in advance.
Pages: [1]