Show Posts
Pages: [1]
1  Topics / Device Hacking / Hacking a Sanyo LC7582 on: April 03, 2013, 01:18:26 am
Maybe this would go over better in this board

http://arduino.cc/forum/index.php/topic,157604.0.html
2  Using Arduino / Displays / Re: Free: 3.2 Sainsmart TFT touch on: April 02, 2013, 01:22:09 pm
 Sent you a PM, thanks man
3  Using Arduino / Displays / Re: Using a Sanyo LC7582 as lcd on: April 02, 2013, 12:40:42 am
I found this which is easier to read...now I am trying to apply it to the LCD

http://www.datasheetcatalog.org/datasheet/sanyo/ds_pdf_e/LC75821E.pdf
4  Using Arduino / Displays / Re: Free: 3.2 Sainsmart TFT touch on: April 02, 2013, 12:36:10 am
Id love to use it for some prototypes I have coming up
5  Community / Exhibition / Gallery / Re: Arduino Nixie Clock > Pics & Source Code on: April 01, 2013, 04:34:12 pm
Not to bring this back up but most of the nixie tubes I have seen require 200v...or atleast say they require 200v, but the kosbo one only ouputs 180v...will it still work at 180v or it just wont be as bright?
6  Using Arduino / Displays / Re: Using a Sanyo LC7582 as lcd on: April 01, 2013, 01:47:30 pm
I can follow the ones in question, and they either end up at a Mitsubishi micro controller or an alpine micro controller

I have a little bit of difficulties reading and understanding the datasheet...
The main issue is that the pins listed on the datasheet do not match that of what is printed on the chip I have...

However I do know based on the datachip that DATA, CE, and CLK go to the controller
7  Using Arduino / Displays / Re: Using a Sanyo LC7582 as lcd on: April 01, 2013, 01:02:54 am
Thanks, I have used many LCD and displays in the past, my issue is instead of the normal ES, RS, RW ports, this LCD has GND, VDD, INH, CE, CLK, DATA, LAMP, LAMP...and I believe the lamp has a ground and positive, i figured that out...but what I dont know is how to interface the rest of these like the normal lcds i have used with the arduino

I know this so far...this is the obvious stuff...

GND - Ground
VDD - 5V
INH -
CE -
CLK -
DATA -
LAMP GND - Backlight Ground
LAMP +B - Backlight +

and now I just need to figure out INH CE CLK and DATA
8  Using Arduino / Displays / Using a Sanyo LC7582 as lcd on: March 31, 2013, 04:29:45 pm
Hey everyone, I am making my own car radio and have pretty much everything done except for the lcd screen...I have a Sanyo LC7582 8D4 screen and have found the data sheet, but didnt know how to implement anything for it in my code...

Here is a link to the datasheet, any help would be great

http://html.alldatasheet.com/html-pdf/40941/SANYO/LC7582/125/1/LC7582.html
Pages: [1]