Show Posts
Pages: [1]
1  Forum 2005-2010 (read only) / Development / Re: Got the internal oscillator working can't use 3.3v on: January 06, 2010, 09:29:45 am
Yes, I did have to change my BOT to a lower value. My new fuses are:

low: E2
high: DA
extended: 06
2  Forum 2005-2010 (read only) / Development / Got the internal oscillator working can't use 3.3v on: January 04, 2010, 01:37:43 pm
I was able to get an Atmega328p (DIP) working with the internal oscillator at 8mhz using a 5v supply, but now it won't run at 3.3v. I'm wondering if I neglected something with my fuse settings, since I've been able to boot 16mhz *duino boards at 3.3v in the past... Or, maybe some weird shenanigans because the firmware is made for the surface mount 'megas...?

My fuse settings and bootloader:
    low fuses: 0xF2
    high fuses: 0xDA
    extended fuses: 0x05
    bootloader: ATmegaBOOT_168_atmega328_pro_8MHz.hex

Thanks for the help

EDIT:
I just figured I'd copy the old revision '168-based Lilypad's fuse bits and now it runs fine. (Though if you notice I'm doing something bad with the fuses, tell me smiley-wink )
    low fuses: 0xE2
    high fuses: 0xDD
    extended fuses: 0x00
    bootloader: ATmegaBOOT_168_atmega328_pro_8MHz.hex

Does anyone know where a nice fuse diagram for the 'megas (including the extended byte) is, and if the '168 and '328 fuse settings are the same? (it seems so from the datasheet I have...)
3  Forum 2005-2010 (read only) / Frequently-Asked Questions / Re: graphical lcd (nokia 3310) on: January 07, 2010, 09:15:44 am
What's on your VOUT from the LCD? I needed to have a 4.7uf capacitor on mine for it to work. (though if it was disconnected entirely it did work somewhat)

Vout -----Cap-----Gnd
Pages: [1]