Hi, so I recently received the most excellent Arduino Mega and I'm having a bit of trouble interfacing it with the ethernet shield like I had hoped I could do. I can't seem to connect with it at all, though I can get a nice display of blinking LEDs while trying.
I have an older arduino NG.C board that I haven't yet tested the shield with (a friend is borrowing it) so my entire problem could be related to it.
My question stems from the fact that the ethernet shield is based on SPI and that the pins for the Mega for SPI seem to be different than the other boards. Could this be the cause of my problems?
Specifically, I will point to these two links:http://arduino.cc/en/Main/ArduinoBoardMega
For the mega, it says SPI is located on pins 50-53 and for the diecimila (pretty close to my Rev C I think) it says that SPI is located on pins 10-13.
Thank you in advance for any help you may provide.