Show Posts
Pages: 1 2 3 [4]
46  Forum 2005-2010 (read only) / Uno Punto Zero / Re: More c# & VB.net source code, together with scetch on: September 10, 2010, 03:54:04 am
Good day

Exactly like this http://blog.renatopeterman.com.br/?p=164#comment-8, but in english, and with tilt support, current version only pans left to right, and i need up & down as well.
and pins 9 for pan & 10 for tilt and not the current pin 8.

Please see what you guys can do for me.

Thanks
Riaan
47  Forum 2005-2010 (read only) / Uno Punto Zero / Re: More c# & VB.net source code, together with scetch on: September 09, 2010, 09:45:40 am
I am an beginner with programming, more an electronics guy.
If anyone got time,and have an idea how to do this, please do this for me.
I have been strugling with this for 2 month.
I have wired everything up, Arduino to sensors, arduino to servo's, arduino to 15 A Pololu MotorDriver and then to 2X 12V drill motors, basically a fully completed robotic tank with CO2 Air rifle for an turret////but I can not control anything////.
I managed to control my motors via Firmata, then tried it with my servos, but they were very shakky,and I would like to push a button to move my servo's, and not move an sider to send PWM to arduino. A simple sketch just for these 5 buttons functioning will be appreciated.

Thanks for the repy. smiley
48  Forum 2005-2010 (read only) / Uno Punto Zero / More c# & VB.net source code, together with scetch on: September 09, 2010, 08:11:49 am
Good day.

I have an Aduino Deumilanouve, and I am strugling to interface simple tasks like to control 3 servo's with 5 butons (servo1 pan left /right) (Servo2 tilt up/down) and the 5th  seperate button to make this third servo go 0*- 180* and then back to 0*.

It will be awesome if this new revision has more support & examples of # & VB.net source code & apps.
I would love it also if the new revision will come out with an app like Firmata, only beter, more push buttons for servo & motor control & less sliders.

If anyone out there can help me with this source code for my Deumlanouve (5 Button servo - control/PWM Pin 9, 10, and 11 )I will realy apprecite it.
see below for example:


Thank you very much,
Riaan Deyzel  
Pages: 1 2 3 [4]