Show Posts
Pages: [1]
1  Forum 2005-2010 (read only) / Interfacing / Transceiver and GPS interfacing on: January 19, 2011, 04:18:57 pm
Hello, I am using the Arduino Mega 2560 board and I am trying to get it to interface with the nRF24LU1+ transceiver and the MN5010HS GPS module. So far I have no clue how to even get a simple output from these devices. The datasheets are very confusing on that part so if someone has experience with these parts can you help me interface them to this board?
2  Forum 2005-2010 (read only) / Exhibition / Re: Arduino GPS waypoints nav for UAVS FINAL!!! on: January 20, 2011, 02:18:26 pm
I have another issue. I understand the code and got it to compile correctly and I ran the static_test example to understand the messages; however, I am now trying to edit the gps_test example to fit my MN5010HS GPS. I suck terribly at hardware so I do don't get anything to output except the messages in the setup function. So for any hardware adept people this is the datasheet http://www.sparkfun.com/datasheets/GPS/MN5010HS_DS_080905.pdf and for my connections I have tried TX to TX and RX to RX and TX to RX and RX to TX with VCC at 3.3 and ground at ground.
3  Forum 2005-2010 (read only) / Exhibition / Re: Arduino GPS waypoints nav for UAVS FINAL!!! on: January 19, 2011, 08:09:21 pm
@knuckles904 Thank you very much. This is exactly what I need.
4  Forum 2005-2010 (read only) / Exhibition / Re: Arduino GPS waypoints nav for UAVS FINAL!!! on: January 19, 2011, 04:33:16 pm
Hey, I am just trying to output GPS messages onto the serial monitor and I am wondering if you can help me Jordi. The GPS I am using is the MN5010HS.
Pages: [1]