Show Posts
Pages: [1]
1  Development / Suggestions for the Arduino Project / LAY-OUT OF THE In-Out PINS on: February 25, 2011, 09:50:32 am
Hallo All,
I have just bought my first ARDUINO UNO three days ago....nothing to say.
NICE JOB, GUYS!

I just have a little suggestion: look at the ARDUINO UNO lay-out of the upper row, the one with the digital out pins.
Well, the step for the all row is NOT 2,54 mm!! (See picture attached)
So, if I have a complete connector of 17 pins (16 connected and one left in the middle of the two female connectors placed on the board) I cannot connect it to the board! This means that I have to cut my piggyback board, and split it in two pieces. Not so nice  smiley-confuse
The bottom one is ok.

I hope you will correct it in the future smiley-wink

Thanks and...go on with this nice idea!!

Ciaooooo

Fabio

Pages: [1]