Show Posts
Pages: [1]
1  Using Arduino / Installation & Troubleshooting / Updating Arduino IDE on: May 08, 2013, 07:52:34 am
Hi,

I've done several projects with Arduino 1.0.1 and some external libraries.
Now I want to update to 1.0.4 but do not want to break the old setup since I do not know if they will work afterwards.

What to do?
Do I need to install the new IDE in a new directory?
Will it use the old libraries or do they need to be installed again in the new environment (1.0.4) ?

-ben

PS I'm using Windows7
2  Using Arduino / Networking, Protocols, and Devices / Re: Looking for MAX1236/1238 code on: June 05, 2012, 03:32:00 pm
After a long time of trial and error, I can read the MAX1236.

-ben

case closed.
3  Using Arduino / Networking, Protocols, and Devices / Looking for MAX1236/1238 code on: June 04, 2012, 11:07:31 am
I'm trying to read values from a MAX1236 AD converter.
Is there anyone who successfully tried this before and is willing to share some code with me ?

-ben
4  Using Arduino / Networking, Protocols, and Devices / Re: I2C questions (which pins?) on: June 04, 2012, 11:05:49 am
It works now, thanks !
5  Using Arduino / Programming Questions / Re: Combine two bytes into one integer to get a 12-bit value. on: June 04, 2012, 03:00:53 am
Hi Vitor2,

Where you able to get the code running with the MAX1236/38? Are you willing to share the code ?

-ben
6  Using Arduino / Networking, Protocols, and Devices / Re: I2C questions (which pins?) on: June 04, 2012, 01:09:14 am
Great, I'll try this tonight!
7  Using Arduino / Networking, Protocols, and Devices / Re: I2C questions (which pins?) on: June 04, 2012, 01:00:08 am
Are the internal pull up resistors not being used ?
8  Using Arduino / Networking, Protocols, and Devices / I2C questions (which pins?) on: June 03, 2012, 03:30:30 pm
Hello,

I'm trying to connect a MAX1236 via I2C to my Arduino Pro board with ATMEGA328.

What is very unclear to me is which pins are used on the Arduino board for SDA/SCL

I've tried pins 20/21 (red this somewhere) also 27/28 (which doesn't work either), connecting a scope to these lines did not show any activity.

Also, how can I override the default settings (I would like to use 27/28 as they are default for ATMEGA328)

Any help greatly appreciated !
9  Development / Other Software Development / Re: Autoload of SerialMonitor after upload on: March 21, 2011, 01:59:36 am
I do understand it is a 'minor' thing compared to the whole Arduino software project but it makes debugging much easier (faster).

-ben
10  Development / Other Software Development / Autoload of SerialMonitor after upload on: March 20, 2011, 04:46:30 pm
Hi,

I do a lot of debugging using the serial port.
Currently when I do an upload, it automatically closes the serial monitor of the IDE, it would be nice if there is an option (checkbox) that would load/open the Serial Monitor automatically after a successful upload of the code into my target.

-ben

Pages: [1]