Show Posts
Pages: [1]
1  Using Arduino / Interfacing w/ Software on the Computer / Very new to the Maxuino thing on: March 22, 2011, 09:04:58 am
Hi there guys, I'm very new to the arduino/maxuino thing but have been using Max/MSP for a few years now.

I'm trying to get an accurate temperature sensor reading into Max/MSP for mapping to parameters.

I have used this temperature sensor setup (http://oomlout.com/a/products/ardx/circ-10/) to get a good reading into the Arduino editor previously but am now trying to get the same level of accuracy in Maxuino.

I have installed everything and uploaded standard firmata onto the board for use in Maxuino and then when pressing (On) on Analog In 0 in the Maxuino GUI I do get a reading but one that only seems to vary from 0.14 to 0.15 when going from ambient to body temperature.
What can I do to get the same level of accuracy as in the Arduino editor in Max?

Apologies if this is a very straightforward task.
Pages: [1]