Show Posts
Pages: [1]
1  Using Arduino / Sensors / AnalogRead input from LabVIEW/DAQ on: March 28, 2011, 01:49:33 pm
Hi all,

I am generating a DC signal in LabVIEW and inputting it into an analog input pin on my Arduino. I am using AnalogRead, reading 1 value every 100 ms. The values that Arduino is receiving (when converted back to volts) are not consistent with the signal that I am outputting from LabVIEW. Thus far, it is difficult to tell where the problem is (Arduino or LabVIEW). Is there something obvious I am missing? Has anyone tried this type of setup before?

Thanks in advance!
Pages: [1]