Show Posts
Pages: [1]
1  Using Arduino / Sensors / Re: IMEI Sensor on: April 27, 2011, 04:30:02 pm
It needs to be able to distinguish device from device.

Could I do a similar form of identification if I turned on bluetooth on all of the devices and used that to determine what devices are near?
2  Using Arduino / Sensors / Re: IMEI Sensor on: April 27, 2011, 05:46:21 am
Hrrm, right, thanks for the great info.

Do you have any other routes you might look into to achieve something similar to what I was trying to do?

Thanks!
3  Using Arduino / Sensors / Re: IMEI Sensor on: April 27, 2011, 05:13:46 am
I guess the problem is that the phone isn't always broadcasting this id like I thought it was. It seems to only do this when trying to connect to a base station. This means I would need to create a device that masquerades as a base station, not impossible but a different problem then I originally thought.
4  Using Arduino / Sensors / Re: IMEI Sensor on: April 27, 2011, 04:57:06 am
Hrrm, ok, thanks. Didn't think it would be that hard. As far as I know the information is unencrypted. I've seen devices for sale but never to the general consumer.
5  Using Arduino / Sensors / Re: IMEI Sensor on: April 27, 2011, 04:33:23 am
i'm looking to identify my devices on the Arduino side using the always on low-power identifiers my devices broadcast to the tower. It will have a list of my ids on a local server and the Arduino will act accordingly when one of my devices is within range.
6  Using Arduino / Sensors / Re: IMEI Sensor on: April 27, 2011, 04:24:09 am
sorry, not all, just mine. in a sense that means all but im just looking to have it identify my devices when they are in range.
7  Using Arduino / Project Guidance / Capturing IMEI data and sending it to a remote server over a wifi network? on: April 27, 2011, 02:46:03 am
What would the cost be to make something like this? I envision it just being plugged into a wall communicating with a wifi network and sending data to a server. I'm guessing this is all feasible but for how much?

The one thing I havent seen is a way to pick up IMEI numbers and the strength of the devices signal. Maybe someone could point me in the right direction?

Thanks!
8  Using Arduino / Networking, Protocols, and Devices / Best way to have an Arduino send data to a server? on: April 27, 2011, 02:17:47 am
I'd like to create a cheap little wifi connected device that can send data to a server. What is the best way to go about doing this?
9  Using Arduino / Sensors / IMEI Sensor on: April 27, 2011, 02:11:35 am
Hey guys, I'm trying to create a device that can pick up my IMEI (International Mobile Equipment Identity) number flying through the air.

Any suggestions?

Thanks!
Pages: [1]